ABB i-bus KNX Product Manual page 57


ABB i-bus KNX
Commissioning
Permit switch-on via dimming
Options:
With this parameter, the switch on behavior of the DALI output is parameterized during dimming with the
central telegram.

Yes: Switch-on using the dim telegram is allowed.

No: Switch-on using the dim telegram is not allowed. The output must be switched on in order to be
dimmed.
Allow switching ON via
brightness values
Options:
Using this parameter, the switch on reaction of the DALI output with a received brightness value
(communication object DALI output: Brightness value) is set.

Yes: Switch-on with a brightness value (8 bit > 0) is permitted.

No: Switch-on with a brightness value is not permitted. The output must be switched on in order to
execute the brightness value telegram.
Allow switching OFF via
brightness value
Options:
Using this parameter, the switch off behavior of the DALI output is set with a received brightness value.

Yes: Switch-off with a brightness value is permitted.

No: Switch-off with a brightness value is not permitted. The output must be implemented with an OFF
telegram via the communication objects Switch or Switch/Status.
Dim period to reach switching value
(function Switch)
Options:
A soft start or soft stop can be set with this parameter. For this purpose, the period is defined, during which
the DLR/S dims the lighting group from 0 % brightness to the switch-on value after receipt of an ON
telegram at one of the central communication objects of output A, Switch or Switch/Status. The same
speed also applies for an OFF telegram. This period is only relevant for central ON/OFF telegrams (1 bit).

Jump to: All the devices on the DALI output immediately switch ON.

0.7 s...90.5 s: During this time, the lighting group is dimmed from 0% brightness to the switch-on
value.
Yes
No
Yes
No
Yes
No
Jump to
0.7 s
2.0 s
...
90.5 s
Flexible dimming time – settable via KNX
DLR/S 8.16.1M | 2CDC 507 100 D0202 55