ABB i-bus KNX Product Manual page 16


ABB i-bus KNX
Device technology
Note
The DALI gateway conforms to the SELV properties to IEC 60 364 4 41 (DIN VDE 0100 410).
DALI does not need to feature SELV properties, and it is possible to route the DALI control lines
together with the mains voltage on a multi-core cable.
All-pole disconnection must be ensured in order to avoid dangerous touch voltages which originate from
feedback from differing phase conductors.
Installation must be performed so that both DALI lines and lines carrying mains voltage are
disconnected when an area is disconnected.
Device type Application
DLR/S 8.16.1M Control Dim Groups 8f DALI/1*
* ... = Current version number of the application. Please refer the software information on our website for this purpose.
Note
ETS and the current version of the device application are required for programming.
Editing with the ETS2 is not possible!
The current application can be found with the respective software information for download on the
Internet at www.abb.com/knx. After the import to the ETS, the application can be found at
ABB/Illumination/Light Controller/Control Dim Groups 8f DALI/1.
The device does not support the locking function of a KNX device in ETS. If you use a BCU code to
inhibit access to all the project devices, it has no effect on this device. Data can still be read and
programmed.
14 2CDC 507 100 D0202 | DLR/S 8.16.1M
Max. number of
communication objects
212
Max. number of Max. number of
group addresses associations
254 255