ABB i-bus
KNX
Appendix
A.5
Code table Status sensors (no. 9)
The status of the 4 light sensors is visible with this communication object. If a light sensor provides a
changed sensor value within a time of 5 seconds, the DALI Light Controller assumes that a light sensor is
not connected or the light sensor is defective.
A missing sensor signal is indicated by a 0 in the corresponding bit of the communication object Status
Sensors (no. 9).
The lowest bit (bit number 0) indicates the status of light sensor A (1). The highest bit (bit number 7)
indicates the status of light sensor H (8).
The following code table shows you the status of all light sensors based on the hexadecimal or decimal
values read from the communication object Status Sensors.
204 2CDC 507 100 D0202 | DLR/S 8.16.1M