ABB i-bus KNX Product Manual page 64


ABB i-bus KNX
Commissioning
Important
Unwanted switching states may result for lighting group devices due to differing status messages within
a lighting group. For this reason, only one communication object should report the status in a lighting
group with several Switch/Status communication objects, in order to eliminate mutual interference of
devices as a result of differing status messages.
With the option Yes: ..., the following parameters appear:
Status response of brightness value
of the DALI output
Options:
The parameter defines how the current status of the brightness value of the output (the lighting) is sent on
the KNX.

No: The brightness value is not actively sent on the KNX.

Yes: via object "Brightness value/Status": The brightness value is sent on the KNX via the
communication object Brightness value/Status.

Yes: via separate object "Status Brightness value": An additional Status Brightness value
communication object for the status message is enabled.
62 2CDC 507 100 D0202 | DLR/S 8.16.1M
Send
Options: After a change
On request
After a change or request

After a change: The status is sent via the communication object after a change.

On request: The status is sent after a request by the communication object Request status
values.

After a change or request: The status is sent via the KNX when the status changes or the
status is requested via the communication object Request status values.
Value for different switching
states at the output
Options: OFF
ON
This parameter defines the status to be sent if DALI devices with different states are present on the
output. This parameter defines the status to be sent if DALI devices with different states are present
on the output.

ON: The switch status is sent as an ON (telegram with the value 1) if at least one DALI device
is switched on.

OFF: The switch status is only sent as an ON (telegram with the value 1) if all DALI devices are
switched on.
No
Yes: via object "Brightness value/Status"
Yes: via separate obj. "Status Brightness value"