ABB i-bus KNX Product Manual page 95


ABB i-bus KNX
Commissioning
Enable function Staircase lighting
Options:
With this parameter, the Staircase lighting function can be enabled for the lighting group.

No: No Staircase lighting function is available for the lighting group.

Yes: The Staircase lighting function is available for the lighting group. The special properties of the
Staircase lighting function are set for the lighting group in the
lighting, page 94. As there is only a timed progress in the DLR/S for the Staircase lighting function, the
times for the staircase lighting progression are parameterized in the
page 43. With an activated Staircase lighting function, the lighting group is switched on, and after a
defined time it is automatically switched off or dimmed down slowly as a warning. The basic
brightness is the brightness, to which the lighting group is set after the staircase lighting time has
elapsed. This basic brightness may also be not equal to zero.
Note
The Staircase lighting function is comprised of two scenes. The DLR/S automatically selects the internal
scenes 13 and 14 when the Staircase lighting function is selected.
For further information see:
No
Yes
Example
This function can ensure that a basic brightness level always exists, for example in the hallways
in nursing homes or hospitals. Maximum brightness is only activated when someone enters the
hallway (detected by a presence detector). It is dimmed down automatically to the basic
brightness, after the staircase lighting time has elapsed and when nobody is in the hallway.
The setting of a warning before the Staircase lighting function switches off is possible using
dimming down. Optionally the warning can be displayed via an additional communication object,
see parameter Enable additional object 1/2.
Staircase lighting, page 167
Parameter window - Gx Staircase
Parameter window
DLR/S 8.16.1M | 2CDC 507 100 D0202 93
General,