Warning Output Flag (Un\G48) - Mitsubishi Electric Q66DA-G User Manual

3
SPECIFICATIONS

3.4.12 Warning output flag (Un\G48)

(1) When the digital input value falls outside CH
(2) Whether the warning is the upper or lower limit value warning can be checked on each
(3) If the warning is detected on any of the channels enabled for conversion, Warning out-
(4) Turning on Operating condition setting request (Y9) or Warning output clear request
Un\G48
(5) Refer to Section 3.2.3 for details of warning output function.
3.4.13
(1) Set whether to enable or disable the scaling on each channel.
(2) To validate the settings, on/off of Operating condition setting request (Y9) is required.
(3) The default setting is all-channel scaling disable.
Un\G53
(4) Refer to Section 3.2.5 for details of warning output function.
3
- 33 3.4 Buffer Memory
3.4.12 Warning output flag (Un\G48)
(Un\G86 to Un\G97) range, the bit corresponding to each channel turns to "1".
channel.
put signal (XE) turns on.
(YE) clears Warning output flag.
b15 b14 b13 b12 b11 b10
0 0 0 0
b12 to b15 information is fixed at 0
CH[ ]Scaling enable/disable setting (Un\G53)
(Refer to Section 3.3.2.)
b15 b14 b13 b12 b11 b10
0 0 0 0
b6 to b15 information is fixed at 0
b9 b8 b7
CH6 CH6 CH5 CH5 CH4 CH4 CH3 CH3
lower upper lower upper lower
limit limit limit limit limit
value value value
value value
b9 b8 b7
0 0 0 0 0
Warning output upper/lower limit value
b6 b5 b4 b3 b2
CH2 CH2 CH1 CH1
upper lower upper lower upper
limit limit limit limit limit
value value value value value
1: Warning output
0: Normal
b6 b5 b4 b3 b2
CH CH CH CH
0
6 5 4 3
1: Scaling disable
0: Scaling enable
b1 b0
lower upper
limit limit
value value
b1 b0
CH CH
2 1