Mitsubishi Electric Q66DA-G User Manual page 114

6
PROGRAMMING
(2) Intelligent function module switch setting
6
- 4 6.2 For Use in Normal System Configuration
6.2.1 Before creating a program
Based on the setting conditions given in Section6.2 (2), make the intelligent function
module switch settings.
(a) Each switch setting
1) Switches 1 and 2: Output range setting
<Switch 2>
0 0 0 0 0
H
CH6 CH5 CH4 CH3 CH2 CH1
0: Fixed
2) Switch3: HOLD/CLEAR setting function
<Switch 3>
0 0 0 0
H
b15 b6 b5 b4 b3
0 0 0 0 0
CH6 CH5 CH4
0: Fixed
3) Switch4: Mode setting
<Switch 4>
0 F 0 0
H
0: Fixed
4) Switch5: Use prohibited (0:Fixed
<Switch 5>
0 0 0 0
H
*1 If any other than 0 is set to Switch 5, an error occurs.
(b) Write the settings in (a) to the Q66DA-G.
On GX Developer's "Parameter setting" screen, select the "I/O assignment" tab,
click "Switch setting", and make settings of Switch 1 to 5 on the screen shown
below.
<Switch 1>
0 3 0
H
CH1 :0 (4 to 20mA output)
H
CH2 :3 (0 to 5V output)
H
CH3 to CH6 :0
b2 b2 b2 b1 b1 b1 b0
0 0 0
CH3 CH2 CH1
CH1 :0 (CLEAR)
CH2 :0 (CLEAR)
CH3 to CH6 :0 (Default)
Setting of normal resolution mode / high resolution mode
All Channels: F
Setting of normal mode / offset/gain setting mode
All Channels: F
*1
)
0: Fixed
(Default)
H
(high resolution mode)
H
(normal mode)
H