Offset/Gain Range Setting (Un\G25); Rate Control Enable/Disable Setting (Un\G46); Warning Output Setting (Un\G47) - Mitsubishi Electric Q66DA-G User Manual

3
SPECIFICATIONS
3.4.9

Offset/gain range setting (Un\G25)

(1) This area is used to change the output range in the offset/gain setting mode. Turning
on Channel change request (YB) changes the output range into the set one.
If any value outside the setting range is set, an error occurs and the corresponding
Error code (Un\G19) is stored.
(2) Channel change request (YB) must be turned on/off to validate the offset/gain range
setting. (Refer to Section 3.3.2.)
(3) Refer to Section 4.6 for details of offset/gain setting.

3.4.10 Rate control enable/disable setting (Un\G46)

(1) Set whether to enable or disable the rate control on each channel.
(2) To validate the settings, on/off of Operating condition setting request (Y9) is required.
(Refer to Section 3.3.2.)
(3) The default setting is all-channel rate control disable.
Un\G46
(4) Refer to Section 3.2.4 for details of rate control function.

3.4.11 Warning output setting (Un\G47)

(1) Set whether to enable or disable the warning output on each channel.
(2) To validate the settings, on/off of Operating condition setting request (Y9) is required.
(Refer to Section 3.3.2.)
(3) The default setting is all-channel warning output disable.
Un\G47
(4) Refer to Section 3.2.3 for details of warning output function.
Output range
User range setting 1
User range setting 2
User range setting 3
b15 b14 b13 b12 b11 b10
0 0 0 0 0
b6 to b15 information is fixed at 0
b15 b14 b13 b12 b11 b10
0 0 0 0 0 0
b6 to b15 information is fixed at 0
b9 b8 b7 b6 b5
CH
0 0 0 0 0
6
b9 b8 b7 b6 b5 b4
CH CH
0 0 0 0
6 5
3.4 Buffer Memory
3.4.9 Offset/gain range setting (Un\G25)
Set value
000F
H
000E
H
000D
H
b4 b3 b2 b1 b0
CH CH CH CH CH
5 4 3 2 1
1: Rate control disable
0: Rate control enable
b3 b2 b1 b0
CH CH CH CH
4 3 2 1
1: Warning output disable
0: Warning output enable
3
- 32
1
2
3
4
5
6
7
8