Mitsubishi Electric Q66DA-G User Manual page 139

7
ONLINE MODULE CHANGE
(c) After confirming that the "RUN" LED of the module has turned off, remove the
(3) Mounting of new module
(a) Mount a new module to the same slot and install the connector.
(b) After mounting the module, click the [Execution] button and make sure that the
7.3.2 When industrial shipment setting is used and initial setting was made with sequence program
connector and dismount the module.
Always perform the dismounting procedure. If mounting confirmation is made
without the module being dismounted, the module will not start properly and the
"RUN" LED will not be lit.
"RUN" LED is lit. Module READY (X0) remains off.
7.3 Online Module Change Procedure
1
2
3
4
5
6
7
8
7
- 11