Selection Of Fixed Setting; Selection Of Factory Setting; Start Of Factory Setting - Siemens simovert masterdrives Operating Instructions Manual

09.2006
NOTE
Siemens AG 6SE7087-2JK50
SIMOVERT MASTERDRIVES
Some parameters may also be displayed without a parameter number,
e.g. during quick parameterization or if "Fixed setting" is selected. In
this case, parameterization is carried out via various sub-menus.
Example of how to proceed for a parameter reset.
P
0.0 A 0 V 00
MotionControl
# 0.00 min-1 *Menu selection
* 0.00 min-1 OP: Upread
Ready
OP: Download

Selection of fixed setting

∇
P
Fixed Setting Fixed Setting
*Select FactSet *Select FactSet
FactSet. #FactSet.

Selection of factory setting

wait
P
Factory Setting Menu Selection
#FactSet. *User Param..
*No FactSet Param. Menu..
busy............ FixedSet...

Start of factory setting

It is not possible to start the parameter reset in the "Run" status.
Operating Instructions
2 x
∇
P
Menu Selection Menu Selection
*User Param. *User Param.
Param Menu.. Param Menu..
Fixed Set... #Fixed Set...
P
Factory Setting Factory Setting
FactSet. #FactSet.
*No FactSet *No FactSet
Parameterization
8-13