Standard Configuration - Emerson Rosemount 3051 Manual

Rosemount Model 3051 Transmitter with F

Standard Configuration

A-10
TM
fieldbus Protocol
OUNDATION
Reference Process Connection
(Low Side)
Isolating Diaphragms
316L SST or Hastelloy C-276
Reference Flange and Adapter
CF-3M (Cast version of 316 SST, material per ASTM-A743)
Non-Wetted Parts
Electronics Housing
Low-copper aluminum or CF-8M (Cast version of 316 SST, material per
ASTM-A743); NEMA 4X,
IP 65, IP 66
Coplanar Sensor Module Housing
CF-3M (Cast version of 316L SST, material per ASTM-A743)
Bolts
Plated carbon steel per ASTM A449, Type 1; Austenitic 316 SST,
ANSI/ASTM-A-193-B7M, or Monel
Sensor Module Fill Fluid
Silicone or inert halocarbon (inert not available with Model 3051CA or
Model 3051H); Model 3051T uses Fluorinert
Process Fill Fluid (Model 3051L and 3051H only)
Model 3051L: Syltherm
inert, glycerin and water, Neobee
®
M-20 , propylene glycol and water, or Syltherm 800. Model 3051H: inert,
Neobee M-20, or D.C. 200 Silicone
Paint
Polyurethane
Cover O-rings
Buna-N
Ordinary Location Certification
As standard, the transmitter has been examined and tested to
determine that the design meets basic electrical, mechanical, and fire
protection requirements by FM, a nationally recognized testing
laboratory (NRTL) as accredited by the Federal Occupational Safety
and Health Administration (OSHA).
Unless otherwise specified, transmitter is shipped as follows:
Engineering units:
Differential/Gage
Absolute/3051T
®
® ®
XLT, D.C. Silicone 704, D.C. Silicone 200,
inH O (Range 1, 2, and 3)
2
psi (Range 4 and 5)
psi (all ranges)
FC-43