Installing The Agilent Chemstation Using The Dvd; Overview; Uninstalling Pre-Existing Agilent Uv-Visible Chemstation Software - Agilent Technologies Cary 8454 Installation Manual

Installing the Agilent ChemStation Using the DVD

Overview

This section explains how to use the Agilent Technologies UV-Visible
ChemStation Software Products DVD to:
• install the Agilent ChemStation for the first time
• upgrade/repair an existing Agilent ChemStation software
• install an additional Agilent ChemStation module
Local Administrator rights on the target PC are required to perform the installation.
NOTE

Uninstalling Pre-existing Agilent UV-Visible ChemStation Software

To remove all analytical ChemStation software from your hard disk for
versions B.05.02 and earlier:
1 Insert your Agilent Technologies UV-Visible ChemStation Software DVD
2 Run the setup program on the DVD.
3 Select Remove and then click Next.
Note that the removal of ChemStation software can also be done from within
the Control Panel.
To remove all analytical ChemStation software from your hard disk for version
B.05.03 ensure the following conditions are met and then follow the procedure
above to uninstall the software.
1 Be logged in as a local administrator such as ChemStationSystem.
2 Have Full Control access to the following:
Agilent Cary 8454 UV-Visible Spectroscopy System Installation Guide
into the drive.
• C:\Chem32
• C:\Chem32\core
Installing the UV-Visible Software
Installing the Agilent ChemStation Using the DVD
5
63