Installing the Cell Stirring Module
1 Remove the thermostattable cell holder from the sample compartment.
2 Remove the three screws that hold the thermostattable cell holder to its
3 Insert the cell stirring module into the cavity in the base of the
Figure 14
4 Tighten the four screws (flathead, M36 mm) that hold the cell stirring
5 Attach the thermostattable cell holder to its base.
6 Mount the thermostattable cell holder back in the sample compartment.
Agilent Cary 8454 UV-Visible Spectroscopy System Installation Guide
base. Remove the cell holder and turn it upside-down.
thermostattable cell holder, see Figure 14.
Installing the cell stirring module
module in place.
Installing Accessories
Cell Stirring Module
4
49