Installing The Long Path Cell Holder; Installing A Sample Cell - Agilent Technologies Cary 8454 Installation Manual

Installing the Long Path Cell Holder

1 Loosen the hold-down screws and remove the current sample holder from
2 Orient the long path cell holder so that the clamps that hold the sample cell
3 Tighten the hold-down screws.

Installing a Sample Cell

1 Position the cell stops according to the path length of the sample cell you
Cell stops
Position cell here
Figure 17
Agilent Cary 8454 UV-Visible Spectroscopy System Installation Guide
the sample compartment.
in place are on the right. Lower the cell holder onto the sample
compartment mounting guides.
will be using. This example shows a 1-cm sample cell:
Positioning the cell stops for a 1-cm sample cell
Installing Accessories
Long Path Cell Holder
Cell clamps
Clamp screws
4
53