Installing The Mirror; Installing The Tube-Cam Camera Option - Agilent 240/280 Aa Only - Agilent Technologies Graphite Tube Atomizer GTA 120 User Manual

Installing the Tube-CAM Camera Option – Agilent 240/280 AA Only
This optional accessory allows you to view images from inside the
graphite tube on your PC so you can monitor sample drying during
method development and accurately set the probe dispensing height
during alignment.
If you have purchased the camera accessory option, the camera will
be installed in your instrument at the factory. Camera drivers are
supplied on a CD-ROM. To install the camera drivers, follow the
instructions on the Installation sheet shipped with the instrument.

Installing the Mirror

You may have ordered a mirror to allow you to view the inside of the
graphite tube in the GTA furnace. This may help in method
development (observing the dry phase) and in setting the PSD
capillary position.
To install this mirror:
1
2
3
The mirror can be rotated and moved up or down the shaft. When
you want to use the mirror, swing the mirror lever so that the mirror
is in front of the atomizer window, and adjust the height and angle of
the mirror so that you can view the inside of the graphite tube
atomizer.
WARNING Eye Hazard
To avoid eye damage DO NOT look at a glowing furnace.
Agilent Graphite Tube Atomizer GTA 120 User's Guide
Remove the chimney.
Clip the mirror mounting block over the bar at the front of the
sample compartment, on the left-hand side.
Tighten the securing screw.
Using Your GTA
35