Installing Preconfigured Agilent Cary 8454 Uv-Visible Systems - Agilent Technologies Cary 8454 Installation Manual

1 Fast Installation

Installing Preconfigured Agilent Cary 8454 UV-Visible Systems

Installing Preconfigured Agilent Cary 8454 UV-Visible Systems
If you have purchased one of these systems, the software is pre-installed and
preconfigured. You need only install and switch on the hardware.
10
Ensure you have space and an appropriate power supply.
For more information, see "Site Requirements for Your
Spectrophotometer" on page 17.
Unpack the system—check for damage and contents against packing list.
For more information, see "Unpacking Your Spectrophotometer" on
page 20.
Install your UV-Visible spectrophotometer.
• Connect line power to the rear.
• Connect the waste tubing underneath the sample pan.
For more information, see "Installing your UV-Visible
Spectrophotometer" on page 21.
Install your computer and printer.
• Connect the keyboard and mouse.
• Connect the monitor to line power and to the computer.
• Connect the printer to line power and to the computer.
• Connect the computer to the spectrophotometer with the LAN cable.
For more information, see "Installing Your Computer" on page 26 and
Chapter 6, "LAN Communication, Installation, Connection and
Configuration".
Switch on the spectrophotometer (make sure the sample area is clear), wait
2 minutes for the lamps to ignite. When you are ready to operate your
spectrophotometer, switch on the computer and printer.
For more information, see "Starting the Spectrophotometer" on page 27.
Agilent Cary 8454 UV-Visible Spectroscopy System Installation Guide