Speed (In User Interface View) - H3C WX Series Command Reference Manual

Parameters
None
Description
Use the shell command to enable terminal services on the user interface.
Use the undo shell command to disable this function.
By default, terminal services are enabled on all user interfaces.
There are a few restrictions on using the undo shell command:

This command is not supported on the console port.

This command is not supported on the AUX port if the device has only a AUX port
and no console port.

This command cannot be used on the user interface from which you log in.
Examples
Disable terminal services on the VTYs 0 through 4.
<Sysname> system-view
[Sysname] user-interface vty 0 4
[Sysname-ui-vty0-4] undo shell
% Disable ui-vty0-4 , are you sure? [Y/N]:y
[Sysname-ui-vty0-4]
The following information is displayed when a Telnet terminal logs in:
The connection was closed by the remote host!

speed (in user interface view)

Syntax
speed speed-value
undo speed
View
User interface view
Default Level
2: System level
Parameters
speed-value: Transmission rate in bps.
The transmission rates available with asynchronous serial interfaces include:

300 bps
95