Schedule Reboot Delay - H3C WX Series Command Reference Manual

After you execute the above command, the AC prompts you to confirm the
configuration. You must enter <Y> or <y> to make the configuration take effect. The
original configuration is overwritten at the same time.
If a date (month/day/year or year/month/day) later than the current date is specified
for the schedule reboot at command, the AC is rebooted at the reboot time.
If you use the clock command after the schedule reboot at command to adjust the
system time, the reboot time set by the schedule reboot at command becomes invalid.
CAUTION:
This command reboots the AC in a future time, thus resulting in service interruption. Please use it
with caution.
Examples
Configure the AC to reboot at 12:00 AM (supposing that the current time is 11:43).
<Sysname> schedule reboot at 12:00
Reboot system at 12:00 06/06/2006(in 0 hour(s) and 16 minute(s)) confirm?
[Y/N]:
If you have used the terminal logging command to enable the log display function on
the terminal before setting a reboot time, the system will automatically display related
log information after you enter <y>. By default, the log display function is enabled.
<Sysname>
%Jun 6 11:43:11:629 2006 Sysname CMD/4/REBOOT:
vty0(192.168.1.54): Set schedule reboot parameters at 11:43:11 06/06/2006, and
system will reboot at 12:00 06/06/2006.

schedule reboot delay

Syntax
schedule reboot delay { hh:mm | mm }
undo schedule reboot
View
User view
Default Level
3: Manage level
Parameters
hh:mm: Device reboot wait time, in the format of hh:mm (hours:minutes). The value of
the hh argument ranges from 0 to 720, and the value of the mm argument ranges from
0 to 59, and the value of the hh:mm argument cannot exceed 720:00.
mm: Device reboot wait time in minutes, in the range of 0 to 43,200.
153