Send - H3C WX Series Command Reference Manual

Set the number of lines displayed on the next screen of console user interface to 30.
<Sysname> system-view
[Sysname] user-interface console 0
[Sysname-ui-console0] screen-length 30

send

Syntax
send { all | num1 | { aux | console | vty } num2 }
View
User view
Default Level
1: Monitor level
Parameters
all: Sends messages to all user interfaces, typically starting from 0
num1: Absolute number of a user interface.
num2: Relative number of a user interface, in the following rules:

For the AUX port, the value is 0.

For the console port, the value is 0.

For VTY user interfaces, the value ranges from 0 to 4.
Description
Use the send command to send messages to the specified user interface(s).
Press Ctrl+Z to end message input and press Ctrl+C to remove this operation when
inputting messages.
Examples
Send the message hello abc to the console user interface.
<Sysname> send console 0
Enter message, end with CTRL+Z or Enter; abort with CTRL+C:
hello abc^Z
Send message? [Y/N]:y
<Sysname>
***
***
***Message from con0 to con0
***
92