Figure 4-2 Connection Description Interface; Figure 4-3 Set The Serial Interface Used For Hyperterminal Connection - H3C LS8M1WCMA0-OVS Installation Manual

Installation Manual
H3C LS8M1WCMA0-OVS Access Controller Module

Figure 4-2 Connection description interface

2) Type the name of the new connection in the connection description interface and
click OK. The system displays the following interface. From the Connect using
drop-down list, select the serial interface to be used.

Figure 4-3 Set the serial interface used for HyperTerminal connection

3) Click OK and the system displays the following interface. On the interface, set Bits
per second to 9600, Data bits to 8, Parity to none, Stop bits to 1, and Flow
control to none.
4-2
Chapter 4 Initial Startup