Make sure that the power On/Off switch is in the Off (O)
Step 8: Plug
Cord Into
position, and then plug the other end of the power cord into a
power outlet of the correct voltage.
Power Outlet
Check to make sure the video refresh switch on the system
Step 9: Check
unit is set to the correct position, according to your monitor
the Video
Refresh Switch
documentation's frequency refresh rate. For monitors that run
at 72 Hz, the switch should be in the up, or two-dot position, as
shown in Figure 3–9. For monitors that run at 66 Hz, the switch
should be in the down, or one-dot position.
Figure 3–9 Checking the Video Refresh Switch
Connecting the DEC 3000 Model 500X AXP Workstation
3
2
IS D N
H z
S3
4
1
H z
5
0
MLO-007546
Installing the System 3–15