Startup Display With Error - Digital Equipment DEC 3000 500X AXP Owner's Manual

After the system startup messages, you may see an error
Error in Startup
Display message rather than the System power up OK message.
Figure 12–2 shows a startup display with an error message.
Figure 12–2 Startup Display with Error
System power up tests detected error(s).
See your system documentation for more information.
Whenever errors are detected, a line on the system startup
display begins with two question marks, followed by a message.
Common There are many reasons for startup errors. When you first
install your system, one of the most common causes of startup
Startup Errors
errors is loose cable connections. Table 12–6 provides the device
components likely to have loose connections.
DEC 3000 - M500
Digital Equipment Corporation
System conducting power up tests.
----------------------------------------------------
Devnam Devstat
-------- ----------
CPU OK KN15-AA - V2.x-S080-IO60 - DECchip 21064 P3.0
ASIC OK
MEM OK 128MB
NVR OK
CXT OK
SCC ?? 003 0050 ptr(0) = Not Present keybd(2) = Not Present
NI OK Ethernet Address: 08-00-2B-1D-1E-EF
SCSI OK
ISDN OK
TC0 OK
----------------------------------------------------
>>>
Startup Problems
Identifying a Problem 12–9