Making Monitor Connectors - Digital Equipment DEC 3000 500X AXP Owner's Manual

Connecting the DEC 3000 Model 500X AXP Workstation
Complete the following steps to connect the monitor cables to the
Step 5: Monitor
Cables to back of the monitor.
Monitor
•
•
•
Table 3–2 Making Monitor Connectors
Step
3–10 Installing the System
Step for a color monitor.
Step for a monochrome or greyscale monitor.
Step for all monitors. Table 3–3 shows the locations of the
connectors on the backs of various monitors. Shaded areas
indicate location of connectors.
See diagram with...
Three connectors
(color monitor)
Five connectors
(color monitor)
Six connectors
(Video In and
Video Out)
One connector
(monochrome
or greyscale
monitor)
Monitor power
cord
Then...
Connect all three cable connectors
to the monitor, matching the color
cables, red (R), green (G), and
blue (B), with the corresponding
connectors marked R, G, and B on
the monitor.
Do not use the H/C and V
connectors. Connect the other
three cable connectors as
described above.
Use the three Video In connectors.
Connect the three cable connectors
as described above.
Connect only the middle, green
(G) cable connector.
Connect the monitor power cord
to the power socket on the rear of
your monitor. The power socket
may be in a different location than
the position shown here. Make
sure the On/Off switch is in the
Off (O) position, and then plug the
other end of the monitor cord into
an appropriate outlet.