Step 2
Step 3
Step 4
Note
Confirming Call Disconnections
To prevent accidental disconnection from a call, you can configure the system to confirm
before a call is disconnected. By default, calls are disconnected when a participant ends the
call, without requiring a confirmation.
Procedure
Step 1
RADVISION | User Guide for SCOPIA XT4000 Series Version 3.1
Select the required option from the Automatic answer list:
•
Yes always: Enables automatic answer to an incoming call. The system will not prompt
you to accept a call if the display shows the Home page.
•
Never: Disables automatic answer to an incoming call. The system will always prompt
you to accept a call.
•
Yes if not in a call (available only for XT Series with a built-in MCU): Enables automatic
answer only if the system is not in a call. If the system is in a call, it displays a
notification about another incoming call, allowing you to accept it. When you are already
in a call and accept an incoming call, the built-in MCU is activated, adding the caller to a
videoconference.
(Optional) Enter the number of rings in the Answer after (Rings) list to specify after how
many rings the system accepts a call. This option is relevant only if automatic answering is
enabled.
In the web interface, select Save.
In the endpoint interface, your changes are automatically saved.
Access the call settings, as follows:
•
From the web interface, navigate to:
Basic Settings > Call-Answer Mode > General.
Figure 3-1
Calling preferences
Tailoring Your User Experience | 25