Figure 15: S-Bus Connected To A Fieldbus Coupler And Modules; 767-6402 4 Ai Rtd - WAGO 767-6402 Manual

WAGO-SPEEDWAY 767

767-6402 4 AI RTD

To connect the S-BUS cables to fieldbus coupler and I/O modules, proceed as
follows:
1. Disconnect the power supply from those devices on which you have
mounted the module.
2. Connect the S-BUS cable (S1) with the OUT connection
fieldbus coupler and the IN connection
For example, if two I/O modules have been connected to the fieldbus
coupler, connect the S-BUS cables (S1, S2) to the associated IN and OUT
connections, as shown in the following figure.
3. Tighten the plugs and sockets using the knurled-head screws.
4. Attach the S-BUS terminator (T) to the last I/O module as shown in the
figure and tighten it.
Pos : 23.13 /Serie 767 ( WAGO-SPEED WAY)/Ansc hluss D aten- und Versorgungs kabel/I/O-M odule/Ansc hlus s_S-BU S_4xM 12 - Bil d @ 5\mod_1249301323125_21.doc x @ 40063 @ @ 1

Figure 15: S-BUS connected to a fieldbus coupler and modules

Pos : 23.14 /D okumentati on allgemei n/Gli ederungsel emente/---Seitenwec hs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Manual
Version 3.1.0
Connecting Data and Supply Cables
3
(3) of the
(1) of the module.
1
43