Analog Inputs; Table 27: Overview Of Adjustable Parameters For The Analog Inputs - WAGO 767-6402 Manual

54 Parameterizing
Pos : 30.12 /Serie 767 ( WAGO-SPEED WAY)/Parametrier en/I/O-Module/Parametrier ung 767-6402 Parameter der Eing änge und anwenderdefi nierte M ess ber eiche @ 5\mod_1249386201671_21.doc x @ 40303 @ 22 @ 1
7.3

Analog Inputs

Table 27: Overview of adjustable parameters for the analog inputs

Parameter
Designation
Display mode process
value
Process image value
Measuring range
Simulation
Upper user limit
Lower user limit
Substitute value
Description
Electronic marking field (max. 40 characters)
Selection of the representation for displaying the process value and limit
values:
- Decimal
- Hexadecimal
- Physical
An updated measured value for the temperature is displayed here.
If the "Simulation" parameter has been activated, enter the simulation
value here.
Select the measuring range here.
You have the following options:
- Pt 100
- Pt 200
- Pt 500
- Pt 1000
- Ni 100
- Ni 120
- Ni 1000
- 1 kΩ resistance
- 4 kΩ resistance
- Potentiometer %
- User-defined 1
- User-defined 2
- User-defined 3
- User-defined 4
Hinweis
Measuring ranges
The user-defined measuring ranges 1 – 4 can by
configured by you. For more information, see section
"Measurement Range User 1 – 4".
If this parameter is activated, you can simulate both the process value
and the channel-specific diagnostics.
Moreover, the input field for the process value is made available so that
you can enter the input value that is to be simulated.
Here you can enter the limit value that is to trigger a diagnostic when
exceeded.
Here you can set the limit value that is to trigger a diagnostic when
under-run.
Here you can enter the process value that is transmitted in the case of an
error.
Default setting: 32767
WAGO-SPEEDWAY 767
767-6402 4 AI RTD
Manual
Version 3.1.0