Selecting The Cutter - Code Soft PL-330D User Manual

1. Enter "Control Panel" → "Device and Printers".
2. Click "Add Printer", then a window of "Add Printer Wizard" pops up, select "Add Local printer
Manually" in the "Local or Network Printer" window.
3. A window of "Select a Printer Port" pops up, according to your requirement, click "Use the Current
Port", select "LPT1: (Printer Port)", serial interface or USB interface, click "Next".
4. A window of "Install Printer Driver" pops up, click "Have Disk...".
5. A window of "Install From Disk" pops up. Please according to the operating system environment,
you should select the path as follows: CD-ROM → "Drivers" → "WIN8(WIN10)", click "Open", then
click "OK" to return to the window of "Install Printer Driver", click "Next".
6. Follow the guide and click "Next" gradually till the installation is finished.

2.6 Selecting the Cutter

Please install the driver following the setup description in the CD going along with the printer. What's
more, you can use the TM-T88II, TM-T88III series driver from EPSON.
If you want to cut the paper after printing each page, please select "cut" or "no cut" in the "Paper
Source" of "Paper/Quality" page after clicking the "Printing Preferences" button, which lies in the
"General" page of the driver properties (as shown below).
Note: if paper cut effect is the same whichever you select "full cut" or "partial cut" in the driver
properties, it means that the cutter (the printer equipped with) can only carry out one
kind of cut-methods.
CODESOFT PL-330 User's Manual
- 8 -