Ldap Parameters - AudioCodes Mediant 500 E-SBC User Manual

User's Manual
Parameter
RADIUS Authentication Parameters
Web: Password Local
Cache Mode
CLI: local-cache-mode
[RadiusLocalCacheMod
e]
Web: Password Local
Cache Timeout
CLI: local-cache-timeout
[RadiusLocalCacheTime
out]
Web: RADIUS VSA
Vendor ID
CLI: vsa-vendor-id
[RadiusVSAVendorID]
Web: RADIUS VSA
Access Level Attribute
CLI: vsa-access-level
[RadiusVSAAccessAttri
bute]
[MaxRADIUSSessions]
EMS: RADIUS Auth
Number of Retries
[RADIUSRetransmission
]
[RadiusTO]
54.14.2.3

LDAP Parameters

The Lightweight Directory Access Protocol (LDAP) parameters are described in the table
below.
Parameter
Web: LDAP Service
CLI: configure
voip/ldap/enable
[LDAPServiceEnable]
Version 6.8
Defines the device's mode of operation regarding the timer (configured
by the parameter RadiusLocalCacheTimeout) that determines the
validity of the username and password (verified by the RADIUS server).

[0] Absolute Expiry Timer = When you access a Web page, the
timeout doesn't reset, instead it continues decreasing.

[1] Reset Timer Upon Access = (Default) Upon each access to a
Web page, the timeout always resets (reverts to the initial value
configured by RadiusLocalCacheTimeout).
Defines the time (in seconds) the locally stored username and
password (verified by the RADIUS server) are valid. When this time
expires, the username and password become invalid and a must be re-
verified with the RADIUS server.
The valid range is 1 to 0xFFFFFF. The default is 300 (5 minutes).

[-1] = Never expires.

[0] = Each request requires RADIUS authentication.
Defines the vendor ID that the device accepts when parsing a RADIUS
response packet.
The valid range is 0 to 0xFFFFFFFF. The default is 5003.
Defines the code that indicates the access level attribute in the Vendor
Specific Attributes (VSA) section of the received RADIUS packet.
The valid range is 0 to 255. The default is 35.
Defines the number of concurrent calls that can communicate with the
RADIUS server (optional).
The valid range is 0 to 240. The default is 240.
Defines the number of retransmission retries.
The valid range is 1 to 10. The default is 3.
Defines the time interval (measured in seconds) that the device waits
for a response before a RADIUS retransmission is issued.
The valid range is 1 to 30. The default is 10.
LDAP Parameters
Enables the LDAP feature.

[0] Disable (default)

[1] Enable
Note: For this parameter to take effect, a device reset is required.
909
54. Configuration Parameters Reference
Description
Description
Mediant 500 E-SBC