AudioCodes Mediant 500 E-SBC User Manual page 30

4. Open the Physical Ports Settings page (Configuration tab > VoIP menu > Network >
Physical Ports Table) and then configure the device's physical Ethernet port-pair
(group) that you want to later assign to the OAMP interface. For more information, see
Configuring Physical Ethernet Ports on page 109.
5. Open the Interface Table page (Configuration tab > VoIP menu > Network > IP
Interfaces Table).
6. Select the 'Index' radio button corresponding to the OAMP + Media + Control
application type, and then click Edit.
7. Change the IP address to correspond with your network IP addressing scheme, for
example:
•
IP Address: 10.8.6.86
•
Prefix Length: 24 (for 255.255.255.0)
•
Gateway: 10.8.6.85
•
Underlying Device: Select the Ethernet Device (VLAN and associated Ethernet
port group) for OAMP
8. Click Submit.
9. Save your settings by resetting the device with a flash burn (see ''Resetting the
Device'' on page 539).
10. Disconnect the device from the PC and cable the device to your network. You can
now access the management interface using the new OAMP IP address.
Note: When you complete the above procedure, change your PC's IP address to
correspond with your network requirements.
User's Manual 30
Mediant 500 E-SBC
Document #: LTRT-10437