AudioCodes Mediant 500 E-SBC User Manual page 569

User's Manual
39.1.5.3.1 Configuring SBC User Info Table in Web Interface
The following procedure describes how to configure the SBC User Info table in the Web
interface.
Note:
removed from the table in the Web interface and replaced with the entries from the
loaded User Info file.

To configure the SBC User Info table in the Web interface:
1. Open the SBC User Info Table page (Configuration tab > VoIP menu > SIP
Definitions > User Information > SBC User Info Table).
2. Click Add; the following dialog box appears:
3. Configure the SBC User Info table parameters according to the table below.
4. Click Submit.
5. To save the changes to flash memory, see ''Saving Configuration'' on page 542.
To register a user, select the user's table entry, and then from the Action button's drop-
down list, choose Register. To un-register a user, select the user, and then from the
Action button's drop-down list, choose Un-Register.
Table 39-3: SBC User Info Table Parameter Descriptions
Parameter
Index
[SBCUserInfoTable_Index]
Local User
[SBCUserInfoTable_LocalUser]
Username
[SBCUserInfoTable_Username]
Password
[SBCUserInfoTable_Password]
IP Group ID
[SBCUserInfoTable_IPGroupID]
Version 6.8
If any User Info file is loaded to the device, all previously configured entries are
Figure 39-3: SBC User Info Table Page
Defines an index for the new table record.
Defines the user and is used as the Request-URI user part for the
AOR in the database.
The valid value is a string of up to 10 characters.
Defines the username for registering the user when
authentication is necessary.
The valid value is a string of up to 40 characters.
Defines the password for registering the user when authentication
is necessary.
The valid value is a string of up to 20 characters.
Defines the IP Group ID to which the user belongs and is used as
the Request-URI source host part for the AOR in the database.
Description
569
39. Software Upgrade
Mediant 500 E-SBC