AudioCodes Mediant 500 E-SBC User Manual page 621

User's Manual
Field
Call End Time
End Point
Caller
Callee
Direction
Remote IP
Duration
Termination Reason
Session ID
Version 6.8
Figure 47-6: CDR History Table
Table 47-3: CDR History Table
Displays the time at which the call ended. The time is displayed in the
format, hh:mm:ss, where hh is the hour, mm the minutes and ss the
seconds (e.g., 15:06:36).
Displays the device's endpoint involved in the call, displayed in the
format:

Analog: <interface>-<module>/<port>. For example, "FXS-3/1"
denotes FXS module 3, port 1.

Digital: <interface>-<module>/<Trunk ID>/<B-channel>. For
example, "ISDN-1/2/3" denotes ISDN module 1, Trunk ID 2, B-
channel 3.
Displays the phone number (source number) of the party who made
the call.
Displays the phone number (destination number) of the party to whom
the call was made.
Displays the direction of the call with regards to IP and Tel sides:

"Incoming": IP-to-Tel call

"Outgoing": Tel-to-IP call
Displays the IP address of the call party. For an "Incoming" call, this is
the source IP address; for an "Outgoing" call, this is the destination IP
address.
Displays the duration of the call, displayed in the format hh:mm:ss,
where hh is hours, mm minutes and ss seconds. For example,
00:01:20 denotes 1 minute and 20 seconds.
Displays the reason for the call being released (ended). For example,
"NORMAL_CALL_CLEAR" indicates a normal off-hook (hang up) of the
call party.
Displays the SIP session ID of the call.
621
Description
47. VoIP Status
Mediant 500 E-SBC