AudioCodes Mediant 500 E-SBC User Manual page 264


To configure an IP Group:
1. Open the IP Group Table page (Configuration tab > VoIP menu > VoIP Network >
IP Group Table).
2. Click Add; the following dialog box appears:
3. Configure an IP Group according to to the parameters described in the table below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Parameter
Common Parameters
Index
[IPGroup_Index]
Type
CLI:type
[IPGroup_Type]
User's Manual
Figure 17-5: IP Group Table - Add Dialog Box
Table 17-5: IP Group Table Parameter Descriptions
Defines an index for the new table record.
Defines the type of IP Group:

[0] Server = Used when the destination address, configured by the
Proxy Set, of the IP Group (e.g., ITSP, Proxy, IP-PBX, or
Application server) is known.

[1] User = Represents a group of users such as IP phones and
softphones where their location is dynamically obtained by the
device when REGISTER requests and responses traverse (or are
terminated) by the device. These users are considered remote (far-
end) users.
Typically, this IP Group is configured with a Serving IP Group that
represents an IP-PBX, Application or Proxy server that serves this
User-type IP Group. Each SIP request sent by a user of this IP
Group is proxied to the Serving IP Group. For registrations, the
device updates its internal database with the AOR and contacts of
Description
264
Mediant 500 E-SBC
Document #: LTRT-10437