AudioCodes Mediant 500 E-SBC User Manual page 245

User's Manual
Hysteresis is also used to configure the threshold. This defines the amount of fluctuation
from a threshold in order for the threshold to be considered as crossed (i.e., change in
color state). Hysteresis is used to avoid false reports.
The following procedure describes how to configure Bandwidth Profiles in the Web
interface. You can also configure Bandwidth Profiles using the table ini file parameter,
BWProfile or CLI command, configure voip/qoe bw-profile.

To configure Bandwidth Profiles:
1. Open the Bandwidth Profile page (Configuration tab > VoIP menu > Quality of
Experience > Bandwidth Profile).
2. Click Add; the following dialog box appears:
The figure above shows a configuration example where if the outgoing voice traffic
threshold of 64,000 increases by 80% (70% warning threshold plus 10% hysteresis) to
115,200 (64,000 plus 51,200), a Yellow state occurs and an alarm is sent. If the
threshold increases by 10%, a Red state occurs and an alarm is sent.
3. Configure a Bandwidth Profile according to the parameters described in the table
below.
4. Click Submit, and then reset the device with a save ("burn") to flash memory.
Table 16-3: Bandwidth Profile Table Parameter Descriptions
Parameter
Index
[BWProfile_Index]
Name
CLI: name
[BWProfile_Name]
Egress Audio Bandwidth
CLI: egress-audio-bandwidth
[BWProfile_EgressAudioBandwidth]
Ingress Audio Bandwidth
CLI: ingress-audio-bandwidth
[BWProfile_IngressAudioBandwidth]
Egress Video Bandwidth
CLI: egress-video-bandwidth
[BWProfile_EgressVideoBandwidth]
Version 6.8
Figure 16-4: Bandwidth Profile Page - Add Record
Defines the index of the table row entry.
Defines an arbitrary name to easily identify the Bandwidth
Profile.
The valid value is a string of up to 20 characters.
Defines the outgoing audio traffic threshold (in Kbps).
Defines the incoming audio traffic threshold (in Kbps).
Defines the outgoing video traffic threshold (in Kbps).
Description
245
16. Quality of Experience
Mediant 500 E-SBC