AudioCodes Mediant 500 E-SBC User Manual page 565

User's Manual
Note:
Source/Destination Number Manipulation'' on page 361), the device applies these
rules before applying the mapping rules of the User Info table.
•
IP-to-IP Calls: Maps SIP From (calling number) and To (called number) of IP PBX
extension numbers with "global" numbers. For example, if the device receives a
call from IP PBX extension number 402 (calling / SIP From) that is destined to IP
PBX extension number 403 (called / SIP To), the device changes both these
numbers into their "global" numbers 638002 and 638003, respectively.

Registering Users: The device can register each PBX user configured in the User
Info table. For each user, the device sends a SIP REGISTER to an external IP-based
Registrar server, using the "global" number in the From/To headers. If authentication
is necessary for registration, the device sends the user's username and password,
configured in the User Info table, in the SIP MD5 Authorization header.
You can configure up to 500 mapping rules in the GW User Info table. These rules can be
configured using any of the following methods:

Web interface - see ''Configuring GW User Info Table in Web Interface'' on page

CLI - see Configuring GW User Info Table in CLI on page

Loadable User Info file - see ''Configuring GW User Info Table in Loadable Text File''
on page
Note:
Registration page (Configuration tab > VoIP menu > SIP Definitions > Proxy &
Registration) as shown:
•
'Enable Registration': Enable (IsRegisterNeeded is set to 1).
•
'Registration Mode': Per Endpoint (AuthenticationMode is set to 0).
39.1.5.2.1 Configuring GW User Info Table in Web Interface
The following procedure describes how to configure and register users in the GW User Info
table in the Web interface.
Note:
Info Table in Loadable Text File'' on page 567), all previously configured entries are
removed from the table in the Web interface and replaced with the entries from the
loaded User Info file.
Version 6.8
If you have configured regular Tel-to-IP manipulation rules (see ''Configuring
567
To enable user registration, set the following parameters on the Proxy &
If a User Info file is loaded to the device (as described in ''Configuring GW User
565
39. Software Upgrade
567
Mediant 500 E-SBC
565