Engineer Programming Via the Keypad
10.17.2 Editing
10.17.3 Deleting
10.18 Setup SMS
84
Siemens Building Technologies
Fire Safety & Security Products
To view and edit and program user rights, enter the programming menus listed
below.
To edit users on the system:
1.
Scroll to the FULL ENGINEER> USERS> EDIT programming option.
2.
Press SELECT.
3.
The following user settings are available to be edited:
Change Name: edit the current user name
–
Change Type: edit the current user type
–
User Options: enable or disable available user options (unset, partset A,
–
isolate, etc.)
Change Areas: enable or disable user access to areas
–
PACE: enable or disable PACE capability
–
RF Fob: enable or disable RF Fob access
–
4.
Press BACK to exit from the USER menu options.
To delete users on the system:
1.
Scroll to the FULL ENGINEER> USERS> DELETE programming option.
2.
Press SELECT.
A prompt is displayed, asking if the user is sure.
3.
Press YES to delete the user.
To set up the SMS functionality on the system:
1.
Scroll to the FULL ENGINEER> SETUP SMS programming option.
2.
Press SELECT.
3.
The following configuration options are available:
Enable SMS: toggle between the SMS ENABLED and SMS DISABLED for
–
preferred option
Phone Number: enter phone number for SMS calls
–
Reported Events: enable or disable SMS calls for specific events; Alarms,
–
Confirmed, Fault, Mode Change, Inhibit Isolate, Other Events
4.
Press BACK to exit the SMS SETUP menu.
09.2008