Editing Communication Connections - Siemens SIMATIC HMI KTP400 Basic Operating Instructions Manual

5.8

Editing communication connections

1. Touch the "Service & Commissioning"
icon.
2. Press the "Edit Connections" button.
With "Edit Connections", you overwrite
the parameters of configured controller
connections
in the current project.
3. A list shows all communication
connections to controllers.
Select a communication connection
from the list.
4. The configured name and IP address
are displayed.
You can enter a new IP address.
5. Set the "Override" switch to "ON".
The connection parameters will only be
overwritten if "Override" is enabled
6. Use the "Accept" button to confirm.
The configured IP address is overwritten.
Basic Panels 2nd Generation
Operating Instructions, 10/2016, A5E33293231-AB
Configuring the device
5.8 Editing communication connections
55