Utilities; Sys Software - Siemens SPC4000 Installation & Configuration Manual

10.13 Utilities

10.13.1 Sys Software

Siemens Building Technologies
Fire Safety & Security Products
Programming options for Utilities are available from the Keypad under the
UTILITIES menu in Tab. 24 listed below. Tab. 25 reveals its location in the Full
Engineer menu.
9
UTILITIES
SYS SOFTWARE
DEFAULTS
FAST PROGRAMMER
SPC Pro
System Options under the UTILITIES Menu
Tab. 24
0
1
2
3
4
5
6
7
8
9
Location of UTILITIES Menu in the Full Engineer Menu
Tab. 25
The following section provides programming steps found within Utlities using the
Keypad. For each menu option, the Keypad must be in Full Engineer programming
and within the menu option UTILITIES:
1. Enter the Engineer Programming code (default 1111).
2. Press SELECT for FULL ENGINEER programming.
3. Using the up and down arrow keys, scroll to the UTILITIES programming
option.
An ellipsis (...) on accompanying graphics denotes when there is a choice of
menu selection by scrolling.
To view the current system software:
1. Scroll to the SYS SOFTWARE programming option.
2. Press SELECT.
The software version currently installed on the system is displayed.
Engineer Programming Via the Keypad
SYSTEM STATUS
VARIABLES
TIMERS
AREAS
XBUS
WIRELESS
ZONES
OUTPUTS
COMMUNICATION
TEST
UTILITIES
81
09.2008