Page 1
The IOP can be fitted to and removed from the inverter while power is applied. The IOP will set the USS PZD (P2012) length to 4 when connected to the inverter. SINAMICS IOP, Getting Started Guide 01/09 - A5E02449215B2...
Page 2
Layout of IOP SINAMICS IOP, Getting Started Guide 01/09 - A5E02449215B2...
Page 3
Locking and unlocking the keypad To lock the IOP keypad press ESC and INFO simultaneously for 3 seconds or more. To unlock the keypad press ESC and INFO simultaneously for 3 seconds or more. SINAMICS IOP, Getting Started Guide 01/09 - A5E02449215B2...
After the Identification screen has been displayed the main status screen is displayed. If the menus are not shown, press the OK wheel to display the menus. The status icons used on the menu are explained below. SINAMICS IOP, Getting Started Guide 01/09 - A5E02449215B2...
Press OK - the cursor will move to the minute field. Rotate the push-wheel until value of the minutes are correct. Using this technique change the day, month and year as required. SINAMICS IOP, Getting Started Guide 01/09 - A5E02449215B2...
Lasten gesichert sind und dass bei einem eventuellen Start des Motors keine gefährlichen Bedingungen bestehen. Das IOP kann im spannungsführenden Zustand an den Umrichter angebaut bzw. entfernt werden. Beim Anschluss an den Umrichter setzt das IOP die USS PZD-Länge (P2012) auf 4. SINAMICS IOP, Getting Started Guide 01/09 - A5E02449215B2...
Page 8
Layout des IOP SINAMICS IOP, Getting Started Guide 01/09 - A5E02449215B2...
Page 9
Drücken Sie für 3 Sekunden oder länger gleichzeitig die Tasten ESC und INFO, um das Tastenfeld des IOP zu sperren. Zum Entsperren desTastenfelds drücken Sie ebenfalls für 3 Sekunden oder länger gleichzeitig die Tasten ESC und INFO. SINAMICS IOP, Getting Started Guide 01/09 - A5E02449215B2...
Page 10
Nach der Anzeige des Identifikationsbildes erscheint die Hauptanzeige. Falls die Menüs nicht angezeigt werden, drücken Sie OK auf dem Navigationsrad, um die Menüs anzuzeigen. Die im Menü verwendeten Zustandssymbole sind nachfolgend erläutert. SINAMICS IOP, Getting Started Guide 01/09 - A5E02449215B2...
Page 11
Drücken Sie OK – der Cursor springt in das Minuten-Feld. Drehen Sie das Navigationsrad bis der korrekte Minuten-Wert erscheint. Gehen Sie analog dazu vor, um Tag, Monat und Jahr auf die gewünschten Werte einzustellen. SINAMICS IOP, Getting Started Guide 01/09 - A5E02449215B2...
Page 12
Printed in the EU (United Kingdom) *A5E02449215B2* SINAMICS IOP, Getting Started Guide 01/09 - A5E02449215B2...