Table of Contents
Advertisement
Engineer Programming Via the Keypad
10.4.1 Ext Bell Time
10.4.2 Int Bell Time
10.4.3 Ext Bell Delay
56
Siemens Building Technologies
Fire Safety & Security Products
This section provides programming steps found within TIMERS using the Keypad.
For each menu option, the Keypad must be in Full Engineer programming and
within the menu option TIMERS:
1.
Enter the Engineer Programming code
(default 1111).
2.
Press SELECT for FULL ENGINEER
programming.
3.
Using the up and down arrow keys, scroll to
TIMERS programming option.
An ellipsis (...) on accompanying graphics
denotes when there is a choice of menu selection by scrolling.
Upon completion of the programming options, the Keypad displays UPDATED
momentarily.
To set the external bell time:
1.
Scroll to the EXT BELL TIME programming
option.
2.
Press SELECT.
3.
Enter the preferred time (0-15 mins)
4.
Press SAVE to update the setting.
To set the internal bell time:
1.
Scroll to the INT BELL TIME programming
option.
2.
Press SELECT.
3.
Enter the preferred time (0-15 mins)
4.
Press SAVE to update the setting.
To set the external bell delay:
1.
Scroll to the EXT BELL DELAY programming
option.
2.
Press SELECT.
3.
Enter the preferred time (0-600 secs)
4.
Press SAVE to update the setting.
FULL ENGINEER
EXIT
SELECT
...TIMERS...
BACK
SELECT
UPDATED
...EXT BELL TIME...
BACK
SELECT
15
(0-15) MIN
BACK
SAVE
...INT BELL TIME...
BACK
SELECT
15
(0-15) MIN
BACK
SAVE
...EXT BELL DELAY...
BACK
SELECT
0
(0-600) SEC
BACK
SAVE
09.2008
- Quick Links:
- Keypad
Hide quick links:
Advertisement
Table of Contents
