Table of Contents
Advertisement
User Menus Via the Keypad
12.11 Changing a User Code
12.12 Using SMS
96
Siemens Building Technologies
Fire Safety & Security Products
If users have the right to change their user code, this can be done through the
Keypad.
Note if the system is set for 5-digit user codes, a new 5-digit code must be entered.
The system will not accept a code with fewer numbers than it is set to receive.
To change a user code:
1.
Scroll to CHANGE CODE and press SELECT
(right soft key).
A randomly generated user code appears.
2.
Select new code, if acceptable. Or overwrite by
entering the new user code and press ENTER
(right soft key).
3.
Confirm the new code, press SAVE (right soft
key).
4.
Press BACK (left soft key) to return to the previous screen to amend the code.
During the process if the display times out, the old code remains valid.
NOTE
Where User Duress feature is enabled, consecutive user codes (i.e. 2906, 2907) are not permitted, as
entering this code from the Keypad would activate a user duress event.
SPC systems with modems and appropriate configuration, allow SMS messaging.
To use SMS, each user must have the appropriate user profile rights. SMS Events
Notification of the following events can be sent to users as SMS messages:
Alarm Activation
Confirmed Alarms
Fault and Tamper
Arming and Disarming (Mode Change)
Inhibit and Isolate
All other types of events
CODE
4740
BACK
SELECT
UPDATED
09.2008
- Quick Links:
- Keypad
Hide quick links:
Advertisement
Table of Contents
