Table of Contents
Advertisement
10.10.2 Programming Outputs
Siemens Building Technologies
Fire Safety & Security Products
Programming options for zones are available from the Keypad under the
OUTPUTS menu in Tab. 17 listed below. Tab. 18 reveals its location in the Full
Engineer menu.
7
OUTPUTS
CONTROLLER
EXPANDERS
EXPANDER 1 IO
System Options under the OUTPUTS Menu
Tab. 17
0
1
2
3
4
5
6
7
8
9
Location of OUTPUTS Menu in the Full Engineer Menu
Tab. 18
The following section provides programming steps found within Outputs using the
Keypad. For each menu option, the Keypad must be in Full Engineer programming
and within the menu option OUTPUTS:
1.
Enter the Engineer Programming code (default 1111).
2.
Press SELECT for FULL ENGINEER
programming.
3.
Using the up and down arrow keys, scroll to
the OUTPUTS programming option.
An ellipsis (...) on accompanying graphics
denotes when there is a choice of menu
selection by scrolling.
Engineer Programming Via the Keypad
OUTPUT1
NAMES
TYPE
MODE
POLARITY
LOG
SYSTEM STATUS
VARIABLES
TIMERS
AREAS
XBUS
WIRELESS
ZONES
OUTPUTS
COMMUNICATION
TEST
UTILITIES
FULL ENGINEER
EXIT
SELECT
...OUTPUTS...
BACK
SELECT
09.2008
73
- Quick Links:
- Keypad
Hide quick links:
Advertisement
Table of Contents
