Shoulder Replacement; Upper Accent Lighting - ergoline Genesis Classic 650 Owner's Manual

Relamping Instructions

Shoulder Replacement

12. Remove screw A. Slightly raise cladding
panel (B) to disengage it from the lower catch,
remove cladding panel towards the front and
place it on the acrylic panel.
(Refer to Illustration L14)
13. To remove lamps turn lamp 1/4 turn and slide
lamp from lampholder.
14. To install lamps place lamp in lampholder and
turn lamp 1/4 turn. To install lamp properly the
lamp etch must be facing the acrylic.
15. To install acrylic assembly engage cladding
panel (B) into the lower catch and secure the
screw (A). (Refer to Illustration L14)

Upper Accent Lighting

16. To detach top unit acrylic apply pressure to
the acrylic assembly and rotate the acrylic
latches clockwise. The acrylic assembly is
attached with two (2) retainers, one at the head
and one at the footend of the canopy.
(Refer to Illustration L15)
17. After detaching the acrylic assembly,
carefully lower the front down, resting the assem-
bly on the base of the unit.
(Refer to Illustration L16)
18. Remove front five (5) tanning lamps. This will
expose inner service panel. Remove inner
service panel by removing screw (A) from the
inside of the head and footend of the unit.
19. Loosen screws (B) from inner panel. Pull red
accent cover from the groove and fold up.
Remove screws (B) at this time.
(Refer to Illustration L15)
20. Remove accent lighting turn lamp 1/4 turn
and slide lamp from lampholder.
21. To install lamps place lamp in lampholder and
turn lamp 1/4 turn.
22. To install red accent cover slide cover into
groove and rotate into place. Attach with screws
(B). (Refer to Illustration L15)
23. Slide inner service panel into place and attach
with screws (A).
Illustration L14
Illustration L15
Illustration L16
8