ergoline Genesis Classic 650 Owner's Manual page 21

Assembly Instructions
28. Illustration A40 Install filter mat B behind
front cross member. Slide both retainer clip over
filter B. Install filter A into place and slide one
clip over filter a to secure.
29. Close service compartment.
30. Illustration A41 Install lamps A inside lamp
panel. Insert lamp in lamp holder and turn 1/4
turn. To avoid potential damage, it is important
not to force the lamp into place. The lamps if
seated in lampholder properly will rotate easily.
31. Rotate starter cover up over head end of
lamps concealing the starters and attach with a
socket head screw. Tighten screw with the
Ergoline Service Key.
32. Rotate side panel acrylic into place and
attach with the acrylic screws. Secure acrylic
assembly with the Ergoline Service Key.
33. Contact Licensed Electrician for unit service
connection. This Ergoline Model 600 must be
connected to a single phase electrical service of
between 220 Volts to 240 Volts. If your salon's
electrical service does not meet these require-
ments refer to pages 20 and 21 of this manual.
21
Illustration A40
Illustration A41