ergoline Genesis Classic 650 Owner's Manual page 13

Disassembly Instructions
18. Close base acrylic assembly.
19. Open service compartment with the service
key. Insert key in the lock and turn clockwise 1/4
turn and raise complete base assembly to it full
upright position.
20. Illustration A9 Remove detent cable B from
service compartment latch assembly from lock F.
Remove cotter pin C and washer G and
disengage cable hook E from lock F. Remove KL
washer D and remove control cable.
Illustration A9
21. Remove the two 8 mm socket head cap
screws A from the longitudinal member and lift
out.
22. Illustration A10 Remove the eight self
tapping screws A that attach the lower front
accent panel. Carefully lift panel up and out of the
lower section.
23. Illustration A11 Detach coupler of left end
gas support spring from ball stud. Lift base
assembly to full upright position. Insert flat blade
screwdriver into slot in coupler and pry coupler
retaining ring back slightly. Apply outward force to
Illustration A10
spring to disengage from ball stud.
24. Repeat procedure 25 for the right end gas
support spring.
25. Place the supporting springs to one side.
26. Disconnect all wiring connections (1.1, 1.2,
1.3, 1.21, 1.30) to the base assembly for removal
of base in step
27. Illustration A12 Locate and remove the two 8
mm base pivot locking screws A.
Illustration A11
Illustration A12
13