Table of Contents
Advertisement
P02
Parameter 2 is the chime mechanism that provides an audible 'beep' sound when the
keys are depressed and to indicate the various operations occurring. The audible beep
can be turned on or turned off. The unit comes with the chime mechanism turned on to
provide an audible beep.
When parameter 02 is shown, the display will read 0001. To maintain the chime
mechanism, press the s now and go to P03. To silence it, do the following:
To Change Parameter 2, Alarm On/Off
Press Reset once then release it. The display will begin to flash. Press t and hold it
down, scrolling down to 0000. Now press Reset once again. The chime is now
deactivated. To reactivate the chime, change parameter 02 back to 0001 using the same
instructions provided above.
Now press Start/Stop to reach parameter 4 P(05), the session delay.
P04
Parameter 4 is the session delay. The session delay allows a programmable amount of
time at the beginning of a session to get ready for the tanning session. The tanning
session time shown on the timer flashes during the session delay. The unit comes with
no session delay preprogrammed.
To Change Parameter 4, Session Delay
When parameter 04 is shown, the display will read 0.0 for no session delay. To change
the session delay, do the following:
Press Reset once then release it, the display will begin to flash. Now press s or tto
reach the desired setting. Time is displayed from 0.0 to 10.0, with the decimal
representing tenths of a minute. For Example: 2.5 equals 2 minutes, 30 seconds. After
reaching the desired setting, press Reset once and release it. Session delay is now set.
Now press Start/Stop to reach Parameter 5 (P05), the Station Address function.
P05
Parameter 5 is the station address. The station address allows the tanning unit to be
identified for interface with the CCS series controllers, the Intellitan Single Station
Console, or the Intellitan Protocol Interface (IPI) for your computer system. The unit
comes with a station address of zero (0) preprogrammed, if you have multiple units each
must be uniquely addressed.
To Change Parameter 5, Station Address
When parameter 05 is shown, the display will read 0000 for station address zero. To
change the station address, do the following:
Press Reset once and release it, the display will begin to flash. Now press s or t to
reach desired address setting. Once the desired setting is reached press Reset once and
release it. The station address is now set.
Now press Start/Stop to reach Parameter 6 (P06), the Lamp-Hour Accumulation on
Current Lamp Bank function.
Hide quick links:
Advertisement
Table of Contents
