ergoline Genesis Classic 650 Owner's Manual page 17

Assembly Instructions
7. Illustration A23 Attach front cross member
tube A to the base assembly with four philips
screws B.
8. Illustration A24 To install the top canopy, lift
canopy into place from both ends. Slide rear pivot
attaching brackets into place aligning with pivot
bearing and attach with three 6 mm socket head
cap screws at each end of top canopy.
Note: Canopy must be supported in the front by
the canopy support to allow installation of the
support rod. Failure to support the canopy will
cause canopy to fall and result in damage to the
unit and possible personal injury.
9. Illustration A25 With canopy supported in it
full upright position by the canopy support install
the canopy support rods. Install support rods by
inserting rod into tubing in leg base assembly.
Attach support rod to canopy by threading the rod
counter clockwise onto rod coupler.
10. Illustration A26 Apply upward pressure to the
front rail of the canopy. Raise canopy high
enough to allow adequate clearance and install
pivot accent panel.
11. Illustration A26 Feed canopy harness cables
through accent panel and connect harness to the
required plugs. Take note to match plug designa-
tion number to corresponding number on recep-
tacle.
17
Illustration A23
Illustration A24
Illustration A25
Illustration A26