To Change Parameters; Enter Password Clearance - ergoline Genesis Classic 650 Owner's Manual

To Change Parameters

To enter the System's data bank, monitor operations and verify the vital functions concerning
your unit, use the following step-by-step instructions. Note: Each timer manufactured after
1995 displays the current software version on power up. These instructions are for level 23
and above of the Intellitan Plus timer.
1.
Press (at the same time) then release s and t buttons; the display will change from
00:00 to 0000
disconnected the network cable(s) from the timer. If power to the tanning unit is not
cycled on/off after disconnecting the network cable, you must wait for thirty seconds for
the timer to award access to the above mentioned buttons.
2.
Press the Reset button once so that 0000 begin to flash.
3.
Use the s button to enter the appropriate password to perform the desired function.
Password 0010 (ten) must be entered to view parameters, and 0102 (one hundred and
two) to edit parameters. After entering the password press the Reset button. The
display will stop flashing and 0001(level one) or 0002 (level two) will appear in the
display.
4.
Press the Start/Stop button to reach the desired parameter. If you go past a parameter
press the st button to exit parameter mode and restart from step 1. Each time the
Start/Stop is pressed the timer will display PXX (XX represents numbers) representing
the parameter reached and then the display will change showing the value of the
parameter.
5.
If you are using the second level password, press the Reset button to edit the parameter
(once the Reset button is pressed the display will begin to flash). Use either the tor s
button to set the appropriate value for the parameter, then press to exit the parameter.
6.
Press the Start/Stop to advance to the next parameter. You may st press buttons
simultaneously to exit the edit parameter mode.

Enter Password Clearance

.
If you cannot get the display to change to 0000, assure that you have