Disassembly Instructions; Tools Required For Assembly - ergoline Genesis Classic 650 Owner's Manual

Disassembly Instructions

Tools Required for Assembly

4 MM Allen Wrench
6 MM Allen Wrench
8 MM Allen Wrench
Ergoline Service Key
10 MM Combination Wrench
Phillips Screwdriver
2 Assembly Rails
1 Upper Canopy Support
Disassembly
1. Illustration A1 Detach side panel acrylic from
profile retaining frame by removing acrylic
attaching screws A with Ergoline Service Key.
Fold down side acrylic panel C.
2. Remove attaching screw from the starter
cover and hinge down.
3. To remove lamps B turn 1/4 turn and slide
lamp from lampholder. Remove all 5 lamps.
4. Illustration A2 Unlock the bottom unit with the
provided Ergoline service key. Insert the key and
turn lock at the head end of the unit and turn 1/4
turn clockwise two times.
5. Raise the lower section to the full upright
position to allow access to the inner unit.
6. Illustration A3 To remove filter mat A from the
front of the base unit. Remove the left hand clip
on grid B and slide right hand clip on grid to the
left of the unit and remove.
11
Illustration A1
Illustration A2
Illustration A3