To Clear Parameter 6, Lamp Hour Accumulation; To Change Parameter 15, Clean Room Feature - ergoline Genesis Classic 650 Owner's Manual

P06
Parameter 6 is the lamp hour accumulation counter. The lamp hour accumulation counter
keeps track of the number of hours on the current lamp bank. This is a resettable
parameter that should be reset to 0 when the lamps are changed. When current lamp hour
accumulation reaches 1000, a beep will chime each time the unit is turned on, indicating
that a lamp change is necessary. Chime will not sound if it has been turned off through
parameter 2. Parameter 6 is only editable at password level 1.
When parameter 06 is shown, the display will read from 0000 to 9999. To clear the lamp
hour accumulator, do the following:

To Clear Parameter 6, Lamp Hour Accumulation

Press Reset once and release, the display will begin to flash. Now press t and hold until
0000 is displayed. When the display reads 0000 press Reset once and release. Lamp
hour accumulation is now cleared.
Now press Start/Stop once and release it to advance to Parameter 15 (P15), clean
room feature.
P15
Parameter 15 is the clean room feature. When "on", the clean room feature will show all
dashes (----) on the timer display at the end of each tanning session to show that the
tanning unit needs to be cleaned. In network mode, no new time can be placed on the
timer when the clean room indicator is displayed.
To reset the clean room feature from the room, indicating that the room has been
cleaned, press the Reset button twice in rapid succession. When the clean room feature
is reset, the in room timer will display 00:00. The unit comes with the clean room feature
off.

To Change Parameter 15, Clean Room Feature

Press Reset once then release it, the display will begin to flash. Now press s once to
display 0001, then press Reset once and release it. The Clean Room Feature is now
enabled. To disable the Clean Room Feature simply change parameter 15 back to 0000.
Now press Start/Stop once and release it to reach Parameter 16 (P16), The
Econometer
P16
Parameter 16 is the Econometer. The Econometer measures the electrical cost to power
unit for previous session or the current session if the tanning unit is active. The cost
displayed is derived from the session cost per minute entered in P17. The reading is
displayed immediately. Measurement is in cents and tenths of a cent. This function is
read only and can not be changed.
For Example - A reading of 10.7 would equal 10.7 cents.
Now press Start/Stop once and release it to reach Parameter 17 (P17), Cost Per
Session.