Instructions For Replacing The Lamps; Nfc: Lamp Replacement (Only Dynamic Power Devices) - ergoline Sunrise 6200 Smart Performance Operating Instructions Manual

Cleaning and maintenance
On the control panel:
Start screen: Welcome to Ergoline
–
Professional Setup Manager (presetting mode)
–
48/73
4.8
4.8.1
Each new set of lamps must be activated with the lamp card supplied. Each
lamp card can only be used once, it is then rendered invalid.
The lamp set have to be installed first, then the lamps must be activated with
the lamp card. To do so, the lamp card must be held in the middle of the di-
rectional pad.
Selection of the device function on the directional pad.
Functions or settings can be activated, deactivated or changed on the directional pad.
Enter the master code.
Press for 3 seconds to open the Professional Setup Manager.

Instructions for replacing the lamps

DANGER!
Danger of burns from hot lamps and surfaces!
Finger and hands may get burned when replacing lamps.
– Before carrying out maintenance work, wait until the
device has cooled down sufficiently.
NOTICE:
Small quantities of mercury can escape if the bulb/lamp
glass breaks! Please comply with the following instructions:

Immediately disconnect the device from the mains pow-
er.

Children must leave the room immediately.

Ventilate the room for at least 15 minutes.

Put on disposable gloves.

With the window open: Collect the glass shards and
escaped mercury in a sealable container.

Bring the container to a collection site for waste lamps.
NFC: Lamp replacement (only Dynamic
Power devices)